start > Sun > LOM Commands

LOM Commands

Created by dave. Last edited by dave, 7 years and 112 days ago. Viewed 10,048 times. #1

[edit] [rdf]

labels

attachments

Command
poweron	powers on the netra
poweroff	powers off the netra
reset	the same as the ok> reset command
reset -x	resets the CPU only, externally initiated reset XIR
break	goes to the ok> prompt from the OS- "Stop-a"
environment	current status of all components in system
check	updates component status after repairing it, run "lom> environment" again
show eventlog	show last 10 events on the system
set faulton	turns on the fault LED
set faultoff	turns off the fault LED
set alarmon [1-3]	sets 1 of 3 alarms on
set alarmoff [1-3]	sets 1 of 3 alarms off
show model	show the server model
show hostname	same as uname -n
show	help for the "show" command
help	list of LOM commands
bootmode -u	allows sharing of the console and LOM device
bootmode normal	server boots using the OBP environment settings; must reset server to take effect
bootmode forth	server stops at the "ok>" prompt- same as "Stop-f"; must reset server to take effect
bootmode reset_nvram	ok> set-defaults" or "Stop-n"; must reset server to take effect
bootmode diag	runs full POST: "ok> diag-switch? true" or "Stop-d"; must power off server and back on within 10 minutes
bootmode skip_diag	ok> setenv diag-switch? false"; must power off server and back on within 10 minutes

no comments | post comment