(2013-10-25)By default, QOS is not enabled on this switch. To enable the default QOS configuration:This should be sufficient for most purposes.Don't forget to save the config.
cat2948-02> (enable) set qos enable QoS is enabled. cat2948-02>
no comments |
post comment
Virtual Dave Megaplex:
Home Page- This wiki's start page
- Send Feedback To Dave
Logged in Users: (1)
Recently Changed
RTC Power Status Failed- System Time
- Client DNS failover behavior
- Packet Dumps
- firewalld
- find
- Cluster Status
- CAA
- Example nmcli Commands
- Windows DDNS Update from Windows DHCP
- snmpd child scripts
- syslog
- Virtual Chassis Setup
- Hyperthreading Experiment
- WebUI Update
- CLI Upgrade Firmware
- CLI Disk Scan Fsck
- Install Grub
- Identifying SSH Key Fingerprints
- List DHCP Client Leases
- winsxs fills system disk
- VPN Debug
- Debug Site to Site VPN
- Show Known Wifi Passwords
- Calculating Network Traffic 95th Percentile
- Start Interface With No IP Address
- Interface Duplex
- CPU is pinned
- snipsnap-portlet-1
- start
Editing: snipsnap-help, Image Macro(Et auditum est, et idcirco ego nunc simulare)
This is a collection of techical information, much of it learned the hard way. Consider it a lab book or a /info directory. I doubt much of it will be of use to anyone else.